Možnosti uporabe lesa v dodajalnih tehnologijah (3D-tiskanju)

Possible uses of wood in additive technologies (3D printing)

Authors

  • Mirko Kariž
  • Milan Šernek
  • Manja Kitek Kuzman

DOI:

https://doi.org/10.26614/les-wood.2017.v66n02a07

Keywords:

3D printing, additive technology, wood, wood residues, wood-plastic composites

Abstract

Additive manufacturing technologies have developed greatly over the last decade in terms of technology and printing materials. Special emphasis is placed on the development of cheaper materials that are derived from natural sources, without the release of harmful substances during the manufacturing process, with the possibility of using waste materials and recycling after service life. Wood or wood residues are among the potential raw materials that could be used for 3D printing in combinations with natural and synthetic polymers. It is anticipated that, with the development of additive technologies, the use of wood will also expand to the area of structural elements, such as in the construction of prefabricated houses. A review of publications on the topic of 3D printing with natural raw materials with an emphasis on wood biomass and technologies, where the use of wood particles is possible, was made.

Downloads

Download data is not yet available.

Downloads

Published

30.11.2017

Issue

Section

Articles

How to Cite

Kariž, M., Šernek, M., & Kitek Kuzman, M. (2017). Možnosti uporabe lesa v dodajalnih tehnologijah (3D-tiskanju): Possible uses of wood in additive technologies (3D printing). Les/Wood, 66(2), 71-84. https://doi.org/10.26614/les-wood.2017.v66n02a07

Most read articles by the same author(s)

1 2 > >>